Hi, I noticed the whatchface position changes in full aod mode.
Specifically, compared to normal mode, when switching to aod mode, the whatchface is moved a few millimeters. This, in some whatchface, represents a problem because it "cuts" some elements.
Is there any way to avoid this?
Thank you
-
- Administrator
-
-
Support Ukraine
If you experience any problems with the forum (it is not visible, there is no way to post messages, or some functionality does not work), please let us know. If you have problems with registration or you did not receive confirmation letter, let us know and we will activate your account manually.
If you get an "The submitted form was invalid. Try submitting again" error, delete cookies, then try again.
Question about aod in T-Rex Ultra
Forum rules
When adding a new topic, use the template: Topic title [device name]
For example: How to create watch face [T-Rex Pro]
All communication in this branch should only be in English.
When adding a new topic, use the template: Topic title [device name]
For example: How to create watch face [T-Rex Pro]
All communication in this branch should only be in English.
When it swaps to Aod mode the position changes every so often so to prevent screen burn I believe
Yes I had imagined, however this would require a solution for those whatcfaces that have symbols, icons and numbers near the "crown" of the watch. Otherwise, when aod takes over, some symbols are cut off.
Again, to a careful observer, the dial appears "shifted".
Again, to a careful observer, the dial appears "shifted".
Who is online
Users browsing this forum: No registered users and 1 guest