Amazfit Watch faces

Hi, I noticed the whatchface position changes in full aod mode.
Specifically, compared to normal mode, when switching to aod mode, the whatchface is moved a few millimeters. This, in some whatchface, represents a problem because it "cuts" some elements.
Is there any way to avoid this?
Thank you

When it swaps to Aod mode the position changes every so often so to prevent screen burn I believe

Yes I had imagined, however this would require a solution for those whatcfaces that have symbols, icons and numbers near the "crown" of the watch. Otherwise, when aod takes over, some symbols are cut off.
Again, to a careful observer, the dial appears "shifted".